|
The
844 System For
gates up to 1800kg.
The
844 system provides a cost effect solution for opening the heaviest
of gates in both Industrial and Commercial applications. Depending
on the type of system installed the electronic equipment can be
fitted remotely or internally, giving you a more efficient installation.
The
casing is made from single high-strength die cast aluminium, together
with constant oil bath lubrication of the mechanical components
gives a very long service life.
| The
844 system uses a disc clutch which is adjustable to specific
torque requirements. The
gear unit on the 844 cannot be reversed but enables manual
operation in the event of a power failure, This can be
available with a customised key.
|
| Gear
motor for the 844 System |
|
| A |
Gear motor 844 |
| B |
Lamp or mini lamp |
| C |
Radio receiver |
| D |
Control devices. Flush
mounting T10 & T11, external T20 & T21, Switch,
Digicard, & Me |
| E |
844 mps, 844 BC Control
unit mps |
| F |
Photo cells. External
Minibeam |
| G |
Safety edge S30 |
| H |
Junction box with
pressure SW |
|
|
SYSTEM 6
- Cantilever Gate
Control:
Card reader entry.
Free exit by induction loop.
A safety photocell system will prevent the gate closing when
the beam is obstructed by a vehicle or person.
Equipment:
1No. Motorised sliding gate
1No. Card reader
1No. Road sensing induction loops Possible additional items:
1No. Pair of photocells.
Civil
work:
Gate installation and card reader base.
Cable ducts to the electric drive unit and card reader post.
Cable ducts to photocell points.
|
Note
1:
The induction loops indicated ' A' and 'B' are positioned
in the road surface.
Type ' A '- To open the gates.
Type ' B '- To provide a safety and gate close feature.
|
|
|
